Ball Y Clevis

BALL Y CLEVIS
Our factory  can make parts according to clients requirement.
1. Material of Line Fitting: Forged-steel

2. Minimum Damage strength of line fitting: 70KN--210KN.

3. Finishing: Hot DIP galvanization. coating average thickness is 70--100 μ M or as Client 's requirements
BALL Y CLEVIS
Our factory  can make parts according to clients requirement.
1. Material of line fitting: Forged-steel

2. Minimum Damage strength of line fitting: 70KN--210KN.

3. Finishing: Hot DIP galvanization. coating average thickness is 70--100 μ M or as Client 's requirements

Cross Arm is an important part of the tower, it is used to install insulators and fittings to support the wire and lightning lines, thus to keep safe distance between them.

According to the use, it can be divided into: straight cross arm; corner cross arm;tension cross arm

According to the material, it can be divided into: iron cross arm; porcelain cross arm; synthetic insulation cross arm.

Cross arm is generally installed at 300mm from the top of the pole, and the straight cross arm should be installed on the receiving side, while the cross arm on the corner pole, the terminal pole and the branch pole should be installed on the guy wire side.

Cross Arm

Cross Arm,Cross Arm For Transmission Line,Galvanized Steel Cross Arm,Angle Iron Cross Arm

Jiangsu Chuandu Electrical Technology Co.,Ltd. , http://www.cdepf.com